TPS2413PW

Texas Instruments
595-TPS2413PW
TPS2413PW

Nsx:

Mô tả:
Hot Swap Voltage Controllers N+1 OR-ing Pwr Rail Cntrlr A 595-TPS2413 A 595-TPS2413PWR

Bảng dữ liệu:
Mô hình ECAD:
Tải xuống Thư viện Tải miễn phí để chuyển đổi tệp tin này cho Công cụ ECAD của bạn. Tìm hiểu thêm về Mô hình ECAD.

Sẵn có

Tồn kho:
Không Lưu kho
Thời gian sản xuất của nhà máy:
12 Tuần Thời gian sản xuất tại nhà máy dự kiến.
Tối thiểu: 450   Nhiều: 150
Đơn giá:
$-.--
Thành tiền:
$-.--
Dự kiến Thuế quan:

Giá (USD)

Số lượng Đơn giá
Thành tiền
$1.87 $841.50
$1.85 $5,550.00
$1.84 $11,040.00

Bao bì thay thế

Nsx Mã Phụ tùng:
Đóng gói:
Reel, Cut Tape, MouseReel
Sẵn có:
Có hàng
Giá:
$2.80
Tối thiểu:
1

Sản phẩm Tương tự

Texas Instruments TPS2413PWR
Texas Instruments
Hot Swap Voltage Controllers N+1 OR-ing Pwr Rail Cntrlr A 595-TPS2413 A 595-TPS2413PW

Đặc tính Sản phẩm Thuộc tính giá trị Chọn thuộc tính
Texas Instruments
Danh mục Sản phẩm: Bộ điều khiển điện áp hoán đổi nóng
RoHS:  
Controllers & Switches
16.5 V
800 mV
1 Channel
7 mA
- 40 C
+ 85 C
SMD/SMT
TSSOP-8
Tube
No
Nhãn hiệu: Texas Instruments
Quốc gia Hội nghị: Not Available
Quốc gia phân phối: Not Available
Quốc gia xuất xứ: MY
Bộ công cụ phát triển: TPS2413EVM
Điện áp đầu vào / nguồn cấp - Tối đa: 16.5 V
Điện áp đầu vào / nguồn cấp - Tối thiểu: 800 mV
Pd - Tiêu tán nguồn: 250 mW
Loại sản phẩm: Hot Swap Voltage Controllers
Sê-ri: TPS2413
Số lượng Kiện Gốc: 150
Danh mục phụ: PMIC - Power Management ICs
Đơn vị Khối lượng: 39 mg
Đã tìm thấy các sản phẩm:
Để hiển thị sản phẩm tương tự, hãy chọn ít nhất một ô
Chọn ít nhất một hộp kiểm ở trên để hiển thị các sản phẩm tương tự trong danh mục này.
Các thuộc tính đã chọn: 0

Chức năng này cần phải bật JavaScript.

CNHTS:
8542399000
CAHTS:
8542390000
USHTS:
8542390090
JPHTS:
8542390990
TARIC:
8542399000
MXHTS:
85423999
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.