TPS24771RGET

Texas Instruments
595-TPS24771RGET
TPS24771RGET

Nsx:

Mô tả:
Hot Swap Voltage Controllers 2.5 to 18V Hot Swap Controller A 595-TPS A 595-TPS24771RGER

Mô hình ECAD:
Tải xuống Thư viện Tải miễn phí để chuyển đổi tệp tin này cho Công cụ ECAD của bạn. Tìm hiểu thêm về Mô hình ECAD.

Có hàng: 1,182

Tồn kho:
1,182 Có thể Giao hàng Ngay
Thời gian sản xuất của nhà máy:
6 Tuần Thời gian sản xuất tại nhà máy dự kiến để có số lượng lớn hơn mức hiển thị.
Tối thiểu: 1   Nhiều: 1
Đơn giá:
$-.--
Thành tiền:
$-.--
Dự kiến Thuế quan:
Đóng gói:
Toàn bộ Cuộn (Đơn hàng theo bội số của 250)

Giá (USD)

Số lượng Đơn giá
Thành tiền
Cut Tape / MouseReel™
$3.51 $3.51
$2.64 $26.40
$2.43 $60.75
$2.19 $219.00
Toàn bộ Cuộn (Đơn hàng theo bội số của 250)
$2.07 $517.50
$1.96 $980.00
$1.91 $1,910.00
$1.88 $4,700.00
$1.85 $9,250.00
† $7.00 Phí MouserReel™ sẽ được thêm và tính vào giỏ hàng của bạn. Không thể hủy và gửi trả tất cả đơn hàng MouseReel™.

Đặc tính Sản phẩm Thuộc tính giá trị Chọn thuộc tính
Texas Instruments
Danh mục Sản phẩm: Bộ điều khiển điện áp hoán đổi nóng
RoHS:  
Controllers & Switches
Programmable
18 V
2.5 V
1 Channel
2.95 mA
- 40 C
+ 125 C
SMD/SMT
VQFN-24
Reel
Cut Tape
MouseReel
Yes
Nhãn hiệu: Texas Instruments
Điện áp đầu vào / nguồn cấp - Tối đa: 18 V
Điện áp đầu vào / nguồn cấp - Tối thiểu: 2.5 V
Loại sản phẩm: Hot Swap Voltage Controllers
Sê-ri: TPS24771
Số lượng Kiện Gốc: 250
Danh mục phụ: PMIC - Power Management ICs
Đơn vị Khối lượng: 54.600 mg
Đã tìm thấy các sản phẩm:
Để hiển thị sản phẩm tương tự, hãy chọn ít nhất một ô
Chọn ít nhất một hộp kiểm ở trên để hiển thị các sản phẩm tương tự trong danh mục này.
Các thuộc tính đã chọn: 0

Chức năng này cần phải bật JavaScript.

CNHTS:
8542319090
CAHTS:
8542390000
USHTS:
8542310030
JPHTS:
854239099
TARIC:
8542399000
MXHTS:
8542399901
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.

TPS2477x High Performance Hot Swap Controllers

Texas Instruments TPS2477x High Performance Hot Swap Controllers are designed for 2.5V to 18V systems. With precise and highly programmable protection settings the TPS2477x aids the design of systems where isolating faults is critical. Programmable current limit, fast shut down, and fault timer protect the load and supply during fault conditions. The fast shut-down threshold can be tuned to ensure a fast response to real faults. Programmable Safe Operating Area (SOA) protection and the inrush timer keep the MOSFET safe under all conditions. After asserting power good, the TPS2477x from Texas Instruments acts as a circuit breaker and runs the fault timer during over current events, but doesn't limit current. The device shuts down after the fault timer expires. Two independent timers (inrush/fault) allow the user to customize protection based on system requirements.